Logo

Code Search

Please fill the "Code Box" to find engine fault code.

Example: 0120

All Engine Codes

The all list of engine trouble codes.

P1205 Engine Diagnostic Code For Gmc Savana 3500

Sample P1205 Engine

P1205 engine code for Gmc Savana 3500 provides below are generic codes that may not apply to all vehicles. Gmc Savana 3500 manufacturer uses specific Gmc Savana 3500 diagnostic code that are different from the codes shown below. Foreign vehicles may also use DTC codes different from the generic DTC codes.

P1205 engine diagnostic code is about in terms of how often you should get your tyres rotated, it's different for every vehicle and type of tyre, but having them rotated at every oil change is a good rule of thumb. Check with the tyre manufacturer for a more specific time frame. Remember that the more often you rotate your tyres, the more evenly they'll wear, and when you have the tyres rotated, you should also get them checked for balance and alignment.

P1205 Diagnostic Trouble Code For Gmc Savana 3500 Meaning

P 1 2 05
Powertrain Problem MFG - Manufacturer Specific Fuel And Air Metering (Injector Circuit Malfunctions Only) 05 Engine Fault Code
Gmc Savana 3500 Car Engine How to fix P1205 engine diagnostic code For Gmc Savana 3500 ?

Starting letter P diagnostic code shows that there are problems in engine, transmission and emissions systems.
If your "Check Engine Light" is on, it means your vehicle has one or more OBD II Trouble Codes so you have to check your engine diagnostic code tool.

If your vehicle is an older model with a non-electronic Fuel And Air Metering (Injector Circuit Malfunctions Only), you can check the distributor cap to see whether the spark is getting from there to the coil and on to the spark plugs.


Don't forget ! If your P1205 engine code not resolved on and there are trouble codes in your computer, your vehicle will not pass an OBD 2 emissions test. The light must be off and there must be no codes in memory to pass an OBD 2 emissions test. In addition, all of the OBD II self-monitors that check for faults must have run and completed without finding any further problems to pass the test.